ХАЛЛ ГРУПП · Equipment catalogue

VOITH IPV3 hydraulic pumps

Internal gear pumps for constant-speed drives using HLP mineral hydraulic oils. Tabulated flow and pressures apply at 20–40 mm²/s viscosity and 0.8–3 bar absolute inlet pressure. Peak pressures apply for 15% of operating time with a cycle not exceeding 1 minute. Price, lead time and supplier stock are confirmed per enquiry.

Open selection and send an enquiry client@hallgroup.ru

Technical parameters

Design: Internal gears, radial and axial sealing gap compensation
Pressure fluid: HLP mineral oils; DIN 51524 part 2 or 3
Line mounting: SAE J518C Code 61
Viscosity range: 10–300 mm²/s
Fluid temperature: −20…+80 °C

Configurations and specifications

Configuration	Technical parameters	IMPA correspondence
IPV3-3.5	Displacement: 3.6 cm³/rev Tabulated delivery at 1500 rpm: 5.4 L/min Speed range: 400–3600 rpm Continuous pressure: 330 bar Peak pressure at 1500 rpm: 345 bar Peak pressure at maximum speed: 345 bar Dimension c in drawing 0/1: 66 mm Table mass for flange 0 / shaft end 1: 4.2 kg	A direct IMPA code is not confirmed
IPV3-6.3	Displacement: 6.4 cm³/rev Tabulated delivery at 1500 rpm: 9.6 L/min Speed range: 400–3600 rpm Continuous pressure: 330 bar Peak pressure at 1500 rpm: 345 bar Peak pressure at maximum speed: 345 bar Dimension c in drawing 0/1: 73 mm Table mass for flange 0 / shaft end 1: 4.6 kg	A direct IMPA code is not confirmed

Selection and applicability

Select the final execution using the full designation, rotation, flange, shaft end and ports. Drawings apply only to the stated 0/1 configuration. Stage combinations and multi-flow assembly interchangeability require separate confirmation. No exact IMPA code is verified.

Photographs and drawings

**VOITH IPV3 — manufacturer dimensional drawing for flange 0 and shaft end 1**IPV3 group drawing from the manufacturer data sheet for mounting flange 0 and shaft end 1. Use the IPV3–3.5 and IPV3–6.3 rows: c = 66 and 73 mm; mass 4.2 and 4.6 kg. Dimension c is not the overall pump length. Both rotation directions are illustrated; this sheet does not establish other flanges, shafts or multi-flow assemblies.

Include with your enquiry

Fluid, temperature, viscosity and solids
Flow and pressure at the duty point; operating cycle
Materials, seals, threads and available power or compressed air

Related sections

Request an offer

The specification, documents and supply terms are agreed for your enquiry. Supplier stock, lead time and price are confirmed in a separate offer.

Open selection and send an enquiry Contacts