Skip to content
RUEN中文
  1. Home
  2. Equipment catalogue
  3. Industrial and air-operated pumps
  4. VOITH IPV5–40 hydraulic pump

ХАЛЛ ГРУПП · Equipment catalogue

VOITH IPV5–40 hydraulic pump

Internal gear pumps for constant-speed drives using HLP mineral hydraulic oils. Tabulated flow and pressures apply at 20–40 mm²/s viscosity and 0.8–3 bar absolute inlet pressure. Peak pressures apply for 15% of operating time with a cycle not exceeding 1 minute. Price, lead time and supplier stock are confirmed per enquiry.

Open selection and send an enquiryclient@hallgroup.ru

Technical parameters

Design
Internal gears, radial and axial sealing gap compensation
Pressure fluid
HLP mineral oils; DIN 51524 part 2 or 3
Line mounting
SAE J518C Code 61
Viscosity range
10–300 mm²/s
Fluid temperature
−20…+80 °C

Configurations and specifications

ConfigurationTechnical parametersIMPA correspondence
IPV5-40
  • Displacement: 41.0 cm³/rev
  • Tabulated delivery at 1500 rpm: 61.5 L/min
  • Speed range: 400–2800 rpm
  • Continuous pressure: 315 bar
  • Peak pressure at 1500 rpm: 345 bar
  • Peak pressure at maximum speed: 315 bar
  • Dimension c in drawing 0/1: 125 mm
  • Table mass for flange 0 / shaft end 1: 16.7 kg
A direct IMPA code is not confirmed

Selection and applicability

Select the final execution using the full designation, rotation, flange, shaft end and ports. Drawings apply only to the stated 0/1 configuration. Stage combinations and multi-flow assembly interchangeability require separate confirmation. No exact IMPA code is verified. For oil-immersed installation, flange 0 must not be used; the manufacturer specifies flange version 7 for that case.

Photographs and drawings

VOITH IPV5–40 — manufacturer dimensional table and drawing 0/1
VOITH IPV5–40 — manufacturer dimensional table and drawing 0/1Use the IPV5–40 row: c = 125 mm and mass 16.7 kg; flange 0, shaft end 1. Dimension c is not the overall length. This drawing does not establish a tandem pump configuration. For oil-immersed installation the manufacturer excludes flange 0 and specifies variant 7.

Include with your enquiry

  • Fluid, temperature, viscosity and solids
  • Flow and pressure at the duty point; operating cycle
  • Materials, seals, threads and available power or compressed air

Related sections

Request an offer

The specification, documents and supply terms are agreed for your enquiry. Supplier stock, lead time and price are confirmed in a separate offer.

Open selection and send an enquiryContacts